Install front underbody protection
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Insert front underbody protection (1) and position correctly.
- Tighten screws (arrows).TIGHTENING TORQUES SPECIFICATION
Undershield/frame Hexagon screw Tightening torque 3 Nm Installing the front skid plate
NOTE: The following step(s) must be performed if the specified component(s) is/are installed. - Feed in and position the front skid plate.
- Tighten down screws (2) and (1).TIGHTENING TORQUES SPECIFICATION
Skid plate at the front to front subframe M8 Tightening torque 19 Nm - Tighten screws (arrows).TIGHTENING TORQUES SPECIFICATION
Undershield/frame Hexagon screw Tightening torque 3 Nm