Remounting the LED module for the daytime driving lights

NOTE: Description is for left component only. Procedure on the right side is identical.

Removing the LED module for the daytime driving lights

Loosen screws (1).
Pull LED module (2) out of headlight.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock connector (1) at LED module (2) and disconnect it.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the LED module for daytime driving lights
Check the seal (3) on the LED module (2) for damage and replace as needed.
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the LED module (2) in the headlight.
Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

LED module of daytime running lights
Screw	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.