Installing the control unit for the Front Light Electronics Left (FLEL)

• Check the seal (3) on the control unit for the Front Light Electronics (2) for damage and replace if necessary.
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Check 

• After locking: The plug connection must be checked for correct, firm fit.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The firm fit is not correct.

Measure

• Disconnect the connectors and check the locking mechanism for mechanical damage.

Measure

• Replace the damaged plug components.

Measure

• Fit, insert and lock the connector at a right angle to the direction of insertion.

Measure

• Check correct firm fit again.

• Position the control unit for the front light electronics (2) in the headlight.
• Tighten down screws (1).

Frontal Light Electronics (FLE)
PT-SCREW 40x12	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PROCESSING THE LED HEADLIGHT SERVICE TEST MODULE .