Installing the LED module for the right daytime running lights

NOTE: Description is for left component only. Procedure on the right side is identical.

• Check the seal (3) on the LED module (2) for damage and replace as needed.
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the LED module (2) in the headlight.
• Tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

LED module of daytime running lights
Screw	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.