Installing the supports for the exhaust covers left and right
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the bracket (2) together with the exhaust cover.
- Tighten the screws (1)
.TIGHTENING TORQUES SPECIFICATION
Exhaust cover holder to bumper panel Screw tightening torque 3 Nm - Mount blind rivet (2) using the special tool 0 496 521 (002 230)
- Tighten down screw (1)
.TIGHTENING TORQUES SPECIFICATION
Exhaust cover holder to bumper panel Screw tightening torque 3 Nm