Replace the support for the bumper cover

NOTE: Perform the steps on the right and left side.

Loosen screws (1).
Remove the support for the bumper cover (2).
Replace the support for the bumper cover (2).
Parts: Support for the bumper cover.
If necessary, remount existing holders on the new support for the bumper cover.

Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

Vertical connection to support for bumper cover
M6x20 screw	Tightening torque	11.8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.