3341 Rear Wheel Bearings
3341 TIGHTENING TORQUE OVERVIEW
| Output shaft to wheel bearing | ||
| M16 Replace the collar screw. |
Snug torque | 210 Nm |
| Angle of rotation | 90° | |
| Wheel bearing to wheel carrier | ||
| M12 Replace spherical collar screws. |
The tightening sequence must strictly be followed and carried out on all spherical-collar screws at the same time! | |
| Tighten the spherical-collar screws in crosswise sequence. | Tightening torque | 20 Nm |
| Initial torque | 140 Nm | |
| Unscrew all bolts. | max. 45° | |
| Tightening torque | 120 Nm | |
| Angle of rotation | 90° | |