Connecting the connector of the DME control unit for cylinders 1 to 4

NOTE: TECHNICAL INFORMATION
Vehicle programming/coding must be performed after installation.
For additional information see: ENCODE/PROGRAM CONTROL UNIT(S) .

NOTE: TECHNICAL INFORMATION
If control units are disconnected, fault memory entries and functional limitations may occur.
The fault memory entries must be read out and deleted if necessary.

Connect connectors (3) and lock.
The connectors (3) must engage audibly.
Connect connectors (2) and lock.
The connectors (2) must engage audibly.
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide cover (1) in the arrow direction and install it in holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Ensure that locks (1) engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.