Installing the vibration damper
- Clean the contact surface of the central bolt (7) .
- Align and position vibration damper for the Woodruff key of the sprocket wheel.
- Position shim (4) .
- Position fitting sleeve (2)
.
The grooves (6) of the fitting sleeve (2) must point to the counter support (5) .
- Position counter support (5) .
- Tighten the screws (1)
and (3)
hand-tight.
- Replace central bolt (2)
.
Parts: Central bolt
- Treat the contact surface (1)
of the central bolt (2)
with lubricating grease.CONSUMABLE SPECIFICATIONS
Lubricating grease SYNTHESO GLEP 1 100 g, Tube 83239407778 - Tighten central bolt (7)
.TIGHTENING TORQUE SPECIFICATIONS
Central bolt Screw M18x1.5x122
Replace screw.
Replace screws grease screw head see Consumables 4.8Joining torque 100 Nm 1. Angle of rotation 60° 2. Angle of rotation 60° 3. Angle of rotation 60° - Release the counter support (5) and the shim (4) with the screws (1) .
- Release the fitting sleeve (2) and counter support (5) with the screw (3) .
- Remove the counter support (5) from the vibration damper.
- Remove the fitting sleeve (2) .
Follow-up work
- Refer to INSTALLING THE BELT PULLEY ON THE TORSIONAL VIBRATION DAMPER .
- Refer to INSTALLING THE BELT TENSIONER .
- Refer to INSTALLING DRIVE BELT .
- Refer to CHECKING THE COOLANT LEVEL IN THE LOW-TEMPERATURE COOLANT CIRCUIT AND TOPPING UP, IF NEEDED .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE RIGHT AND LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING BOTH INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .