1112 CYLINDER HEAD (X6 M50i)

1112 TIGHTENING TORQUE OVERVIEW

Cylinder head bolt
M11 Replace screws.	Joining torque	30 Nm
	1. Angle of rotation	90°
	2. Angle of rotation	140°
Cylinder head bolt to timing case cover
M8x30	Tightening torque	23 Nm
Cylinder head cover to cylinder head
M6x30 screw	Tightening torque	10 Nm
Cylinder head to special tool
screw	Tightening torque	25 Nm
Engine suspension element
M8x22 screw	Tightening torque	20 Nm
Flange to assembly jig
M14X30	Tightening torque	135 Nm
Fuel line
M6x16	Tightening torque	10 Nm
Intake/exhaust camshaft
M6	Snug torque	10 Nm
	Tightening torque	10.5 Nm
Oil filler neck
M6x16	Tightening torque	10 Nm
Special tool to cylinder head 1 to 4
M6x15	Tightening torque	10 Nm
Special tool to cylinder head bank 2
M8 screw	Tightening torque	25 Nm
Stud bolt on cylinder head
M8x50 Replace the stud bolt.	Tightening torque	20 Nm
Timing case cover on cylinder head
M6x20 screw	Tightening torque	9.5 Nm
Valve in cylinder head
valve	Tightening torque	0.8 Nm
Venting connector/special tool to cylinder head
M8x1 Replace the venting connector.	Tightening torque	15 Nm