Install exhaust cover

• Insert the exhaust cover (2)  on the holder and engage at detent (3).
• Replace screws (1)  .

  Parts:  Screw

• Tighten down screws (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Exhaust cover on holder
  Screw Replace screw	tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the bracket (2)  together with the exhaust cover.
• Tighten down screws (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Exhaust cover holder to bumper panel
  Screw	tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Mount blind rivet (2) using the special tool 0 496 521 (00 2 230) .
• Tighten down screw (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Exhaust cover holder to bumper panel
  Screw	tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING THE RIGHT D-PILLAR TRIM PANEL .
• Refer to INSTALLING THE COVER OF THE RIGHT BELT FEED TRIM .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE BATTERY COVER .
• Refer to INSTALLING THE COVER OF THE SIDE MEMBER ON THE RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING THE STORAGE SHELF .