Removing the center cowl upper part

NOTE: TECHNICAL INFORMATION
Before installing the cowl cover, it is imperative to check the correct routing and firm fit of the 48V line.
An incorrectly laid or attached 48V line can be damaged by the wiper kinematics.

Preliminary work

Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
Refer to REMOVING LEFT AND RIGHT WIPER ARM .
Refer to REMOVING WINDSHIELD PANEL COVER .
Refer to REMOVING THE REAR HOOD SEAL .

Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the wire (1) with the bracket from the center cowl upper part (3).
Loosen screws (2).
Remove the center cowl upper part (3).

Courtesy of BMW OF NORTH AMERICA, INC.