Installing the door sill cover strip on the rear left and right
NOTE:
Perform the steps on the left and right side.
Install the rear door sill cover strip
NOTE:
RISK OF DAMAGE
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Version A with basic seat:
- Remove the clips (1) remaining in the body and mount them on the door sill cover strip (3).
- Check if the clips (1) and the guide (2) are damaged and if available.
The clips (1) and the guide (2) must not be damaged or missing.
- Version A with basic seat:
- Position the rear door sill cover strip (2) on the body.
- Engage rear door sill cover strip (2) on the clips (3).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Door sill cover strip to body | ||
| Screw 4, 8x16 | Tightening torque | 1.4 Nm |
Installing the illuminated sill trim on the rear door sill
NOTE:
RISK OF DAMAGE
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Check the detents (2) for damage, if necessary replace the illuminated sill trim (1).
- Mount the illuminated sill trim (1) and connect and lock the connector while doing so.
- Position the illuminated sill trim (1) and lock at the detents (2).