Installing the acoustic cover for the oil sump

• Feed in and install the acoustic cover (2) of the oil pan.
• Secure expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the Christmas tree clip (1) for damage, replace if necessary.

  Parts:  Fir tree clip

• Secure the fir tree clip (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure expanding rivets (1) and (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
• Position the transmission oil lines (1) on the bracket (2).

  Make sure that the marks (3) have been positioned correctly on the holder (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
• Insert and install the holder (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Holder for transmission oil line
  Screw	Tightening torque	4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (1).
• Make sure the connector (1) engages audibly.
• Secure clamps (2).
• Insert and install the positive battery cable (4).
• Secure positive battery cable (4) at the clamp (5).
• Tighten the nut (3) hand-tight.

  Courtesy of BMW OF NORTH AMERICA, INC.

  CAUTION: Improper routing of the positive battery cable. 
  Risk of short circuits! 

  • Route the positive battery cable without abrasions and do not trap.
• Attach the positive battery cable (1) correctly  to antitwist lock (2).
• Tighten nut (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to DEACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .