Install the lower oil pan section
NOTE:
TECHNICAL INFORMATION
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
- Clean the sealing surface in the area of (1) with the special tool 0 495 102 (11 4 470).
- Remove the seal (1).
- Clean sealing surfaces with special tool 0 495 102 (11 4 470) .
- Replace the seal (1).
Parts: Seal
- Position the seal (1) on the lower oil pan section (2).
- Position the lower oil pan section.
- Replace screws.
Parts: Screws
- Tighten the screws in this area (1).TIGHTENING TORQUE SPECIFICATIONS
Lower oil pan section to upper oil pan section M8 Replace screws. tightening torque 27 Nm - Connect connectors (2) and lock.
- Attach the cable clip (1).
Follow-up work
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to REMOVING THE OIL FILLER CAP .
- Refer to FILLING ENGINE OIL .
- Refer to INSTALLING THE OIL FILLER CAP .
- Refer to CHECKING ENGINE OIL LEVEL .