Installing rear brake hose
- Attach brake hose to the holder (1).
- Fit and tighten brake hose (2) on brake caliper.
Never twist brake hose and avoid all contact with components attached rigidly to the body.
TIGHTENING TORQUE SPECIFICATIONSBrake hose to brake caliper, rear tightening torque 24 Nm - Attach and tighten union screw (1).
Hold on to square shaft, if necessary (2).
TIGHTENING TORQUE SPECIFICATIONSBrake pipe screw connection/Union screws tightening torque 17 Nm
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH THE REAR BRAKE AND AIR BLEEDING (AFTER PART EXCHANGE) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .