Remounting the EMF actuator

Release screws (3) and remove the holder (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the EMF actuator (1) in the direction of the arrow from the brake caliper.

Courtesy of BMW OF NORTH AMERICA, INC.
EMF actuator (1) Carefully fit controller drive until gearing engage and EMF actuator rests flush on brake caliper.
If necessary, turn the EMF actuator slightly until the bore and the screw thread are aligned.

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the holder (4) and position and tighten the bolts (3).

TIGHTENING TORQUE SPECIFICATIONS

EMF actuator to brake caliper
Replace screws.	tightening torque	12 Nm

Courtesy of BMW OF NORTH AMERICA, INC.