Installing the pressure line between the evaporator and the air conditioning condenser

• Replace the sealing ring (1)  of the refrigerant line (2)  .
• Replace sealing ring (1)  .

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly feed in and position the pressure line (2)  between the evaporator and the air conditioning condenser.
• Fit the pressure line (2)  on the air conditioning condenser.
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace sealing rings.

  Parts:  Sealing ring

• Fit the pressure line (3)  on the expansion valve.
• Tighten nut (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Engage the hose support (2)  on the pressure line (3)  .
• Close the holder (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to ATTACHING THE INTAKE PIPE ON THE AIR CONDITIONING COMPRESSOR .
• Refer to INSTALLING THE SAFETY PRESSURE SWITCH .
• Refer to INSTALLING THE HOLDER FOR THE DME CONTROL UNIT ON THE LEFT .
• Refer to INSTALLING THE DME CONTROL UNIT OF CYLINDERS 5 TO 8 .
• Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
• Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
• Refer to MOUNTING THE WHEEL .
• Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .
• Refer to EVACUATING AND CHARGING CONDITIONING .