Installing the guide for the rear bumper panel at the side

• Correctly position the guide for the rear bumper panel at the side (3).
• Tighten nuts (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper guide, rear
  Nut	Tightening torque	6 Nm

• Tighten down screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper panel, rear
  Hexagon screw	Tightening torque	3.0 Nm

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE REAR DIFFUSER .
• Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING THE RIGHT D-PILLAR TRIM PANEL .
• Refer to INSTALLING THE COVER OF THE RIGHT BELT FEED TRIM .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE BATTERY COVER .
• Refer to INSTALLING THE COVER OF THE SIDE MEMBER ON THE RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING THE STORAGE SHELF .