Replace the support for the bumper cover
NOTE:
Perform the steps on the right and left side.
- Loosen screws (1) .
- Remove the support for the bumper cover (2) .
- Replace the support for the bumper cover (2)
.
Parts: Support for the bumper cover
Parts: Support for the bumper cover
- If necessary, remount existing holders on the new support for the bumper cover.
- Tighten down screws (1)
.TIGHTENING TORQUES SPECIFICATION
Vertical connection to support for bumper cover M6x20 screw Tightening torque 11.8 Nm