Replacing the radial shaft seals

Replacing the radial shaft seal

NOTE: TECHNICAL INFORMATION
Radial shaft seal ring are equipped with an installation protection ring. The installation protection ring is used to protect the sealing lip when installing the output shaft.

Remove the radial shaft seal

Pull out radial shaft seal with the aid of special tools 0 490 466 (00 5 010) and 0 495 597 (24 2 354).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace radial shaft seal (2).
Parts: Radial shaft seal
Remove the installation protection ring (1) from the radial shaft seal (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Install the radial shaft seal
Coat the housing of the sheet metal flange of the radial shaft seal with the approved front differential fluid.
Drive in the radial shaft seal to the stop using the special tool 0 493 539 (31 5 130).
Remove the special tool 0 493 539 (31 5 130).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the installation protection ring (1) again in the radial shaft seal (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the radial shaft seal of the bearing bracket

NOTE: TECHNICAL INFORMATION
Radial shaft seal ring are equipped with an installation protection ring. The installation protection ring is used to protect the sealing lip when installing the output shaft.

Removing radial shaft seal of the bearing bracket
Prepare the special tool 0 490 466 (00 5 010) with the special tools 0 494 649 (21 2 230) (without the screw) and 0 493 384 (11 1 212).

Courtesy of BMW OF NORTH AMERICA, INC.
Pull out and remove the radial shaft seal (1) with the special tools 0 490 466 (00 5 010), 0 494 649 (21 2 230 ) and 0 493 384 (11 1 212).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace radial shaft seal (2).
Parts: Radial shaft seal
Remove the installation protection ring (1) from the radial shaft seal (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing radial shaft seal of the bearing bracket
Coat the housing of the sheet metal flange of the radial shaft seal with the approved front differential fluid.
Drive in the radial shaft seal to the stop using the special tool 0 493 539 (31 5 130).
Remove the special tool 0 493 539 (31 5 130).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the installation protection ring (1) again in the radial shaft seal (2).

Courtesy of BMW OF NORTH AMERICA, INC.