Install the left-hand and right-hand crash lever

NOTE: Perform the steps on the right and left side.

Replace screws on the right.
Parts: Screws

Installing crash lever

NOTE: The following step(s) must be performed if the specified component(s) is/are installed.

NOTE: TECHNICAL INFORMATION
Do not mix up the left and right!
Position the crash lever (3).
Replace screws (1) and (2).
Parts: Screws

Tighten down screws (1) and (2).

TIGHTENING TORQUE SPECIFICATION

Crash lever to front subframe/frame
M12 Replace screw.	Tightening torque	68 Nm

G16262448

Courtesy of BMW OF NORTH AMERICA, INC.