Prepare installation
- Protect the vehicle interior against contamination.
- Clean body aperture (1) in the area of the adhesive bead.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean the painted metal surfaces without the adhesive bead.CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - After cleaning, allow to air out.TECHNICAL DATA SPECIFICATION
Air drying time after cleaning Window glass or painted panel without residual adhesive bead 5 min Body with adhesive bead 15 min - Shortly before adhesion with the standard tool, remove adhesive bead (1) on the body aperture.
Standard tool:
Pinchweld scraper set
Pinchweld scraper set
81 62 0 410 436
NOTE:
TECHNICAL INFORMATION
Do not touch the adhesive bead after cutting or allow it to come into contact with cleaning agents.
Do not touch the adhesive bead after cutting or allow it to come into contact with cleaning agents.
- Apply the pinchweld scraper as shown and cut back the adhesive bead (1).TECHNICAL DATA SPECIFICATION
Residual height of the adhesive bead Residual height of the adhesive bead max. 1 mm - Be sure to touch up paintwork damage.
- Sand large-scale damage down to the bare metal and coat.TECHNICAL DATA SPECIFICATION
HS-AM multi-base filler VOC Layer thickness 30 μm... 40 μm Hardening time with infrared 10 min Hardening time without infrared 60°C 30 min Hardening time without infrared 20°C 1 Tag