Remove the guide for the rear bumper panel on the side
Preliminary work
- Refer to REMOVING THE STORAGE SHELF .
- Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to REMOVING THE COVER FOR THE SIDE MEMBER ON THE RIGHT .
- Refer to REMOVING BATTERY COVER .
- Refer to REMOVING THE LOADING EDGE TRIM .
- Refer to REMOVING THE COVER OF THE SEAT BELT FINISHER STRIP ON RIGHT .
- Refer to REMOVING THE RIGHT D-PILLAR TRIM PANEL .
- Refer to REMOVING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to REMOVING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Refer to REMOVING THE FLAP IN THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
- Refer to REMOVING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANEL .
- Refer to REMOVING LEFT AND RIGHT REAR REFLECTORS .
- Refer to REMOVING THE REAR DIFFUSER .
- Refer to REMOVING THE REAR BUMPER COVER .
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Loosen screw (1) .
- Loosen nuts (2) .
- Remove the guide for the rear bumper panel (3) on the side.
- If necessary, disconnect the existing plug connections.