Attaching the charge air cooler
- Check the seal (1) for damage and replace if necessary.
- Check sealing ring (1) for damage, replace if necessary.
- Feed the charge air cooler (6) in and install it.
- Tighten down screws (5).TIGHTENING TORQUE SPECIFICATIONS
Charge air cooler to holder M6x35 tightening torque 8 Nm - Secure the coolant lines (arrowed) to the clamps.
- Lock clamps (4).
The clamps (4) must engage audibly.
- Connect connectors (3) and lock.
The connectors (3) must engage audibly.
- Insert and install charge air line (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Connecting hose to charge air cooler | ||
| Hexagon screw M6 | tightening torque | 8 Nm |