Install front axle differential
- Check that the O-ring (1) is correctly positioned and not damaged.
- If applicable, correct or replace the O-ring (1).
- Coat the O-ring (1) with front axle transmission oil.
- Position front axle differential (3).
- Make sure the installation locations of the marked screws (1) and (2) are correct.
Screw (1): M12x105
Screws (2): M12x55
- Tighten down screws (1) and (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front axle final drive to motor oil pan | ||
| M12 | Tightening torque | 140 Nm |