Removing intake silencer housing
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
Precondition
- Ignition is switched off.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING RIGHT SUSPENSION STRUT BRACE .
Precondition
Ignition is switched off.
- Unlock and disconnect the plug connection (1) of the Lambda oxygen sensors.
- Unlock the plug connection (2) and disconnect from the holder (3).
- Release the cable (4) of the Lambda oxygen sensor from clamps.
- Loosen clamps (1).
- Release the intake filter housing (1) up out of the rubber mounts (marks).
- Disconnect the intake filter housing (1) from the clean air pipe (2).
- Feed out the cable of the Lambda oxygen sensors through the opening (arrow) on the intake filter housing (1).
- Feed out and remove the intake silencer housing (1).