Installing the throttle body
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the sealing ring (1) with the special tool 0 496 714 (00 9 030)
.
Parts: Sealing ring
- Position throttle body (2).
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Install the throttle body (2).
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Throttle body to intake plenum 6X50 Tightening torque 7 Nm - Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder for coolant hose to throttle body | ||
| M6x16 screw Replace screw. |
Tightening torque | 11.5 Nm |
Follow-up work
- Refer to PARTIALLY INSTALLING THE CHARGE AIR LINE .
- Refer to INSTALLING THE ENGINE CONTROL UNIT COVER .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING ACOUSTIC COVER .