Secure the wishbone on the top left and right on the swivel bearing
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
Fastening the wishbone to the top of the swivel bearing
- Position the pin of the top control arm (3) in the bore of the swivel bearing (4) .
- Replace the screw (2)
and the nut (1)
.
Parts: Bolt and nut
- Insert screw (2) .
- Tighten nut (1)
.TIGHTENING TORQUES SPECIFICATION
Upper wishbone to swivel bearing M10 Replace screw and nut. Tightening torque 56 Nm - Remove the special tool for attaching the swivel bearing.