Secure the juncture shaft in front on the front axle differential

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

Before installing the prop shaft on the front axle transmission, all 4 threads (1) in the front axle transmission flange must be freed of possible residue and contaminations and cleaned.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws.
Parts: Screws

A drop of Loctite 270 (2) must be given before the screw connection on each thread at the end of the respective screw (1) .

Consumable
High-strength screw lock, Loctite 270	10 ml, Tube	83 192210 337

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again.

Position the propeller shaft in front on the front axle differential.
Replace the bolts (arrows).
Parts: Screws

Tighten screws (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Prop shaft before the front axle differential
Replace screws. Joining torque and angle of rotation must be observed without fail.
	Tightening torque	25 Nm
	Angle of rotation	45°