Removing the intake filter housing (tension strut on shock tower removed)

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

Precondition

The tension strut on the shock tower is removed.

Unfasten circlip (1) .
Unlock and detach the connector (2) of the hot film air mass meter.
Loosen screw (3) .
Pull out and remove the intake silencer housing (4) from the rubber mounts towards the top.

Courtesy of BMW OF NORTH AMERICA, INC.