Installing the left and right crash lever

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the steps on the right and left side.

Installing crash lever

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

NOTE: TECHNICAL INFORMATION
Do not mix up the left and right.

Position the crash lever (3) .
Replace screws (1) and (2) .
Parts: Screws

Tighten down screws (1) and (2) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Crash lever to front subframe/frame
M12 Replace screw.
	Tightening torque	68 Nm