Install the rear section of the front wheel arch cover on the left and right

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Description is for left component only. Procedure on the right side is identical.

Install the rear section of the front wheel arch cover

NOTE: To provide a better overview: Schematic diagram with partially hidden components.

Feed in the rear section of the wheel arch cover (1) .

Tighten screws (arrows).

TIGHTENING TORQUES SPECIFICATION

Wheel arch cover
Thermoplastic hexagon screw
	Tightening torque	2.6 Nm
Plastic nut
	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.