Install all ignition coils
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
Install ignition coil
- Install ignition coil (3).
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Ignition coil screw Tightening torque 8 Nm - Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Mount the connector (1) of the Lambda oxygen sensor and the oxygen sensor monitor on the cable duct (2).