If installed: Fasten the auxiliary heater

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

Position the stationary heating system.

Tighten down screws (2) .

TIGHTENING TORQUES SPECIFICATION

Holder to body
M8
	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten nuts (1) .

TIGHTENING TORQUES SPECIFICATION

Stationary heating system to holder
M8
	Tightening torque	19 Nm

Installing the front section of the front wheel arch cover

NOTE: To provide a better overview: Schematic diagram with partially hidden components.

Guide in the front section (1) of the wheel arch cover.

Tighten screws (arrows).

TIGHTENING TORQUES SPECIFICATION

Wheel arch cover
Thermoplastic hexagon screw
	Tightening torque	2.6 Nm
Plastic nut
	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.