Attach the wiring harness of the active stabilizer (additional work, flat rate unit number: 37 11 999)

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Secure cable with the holders (3) on the side member.
Connect connectors (2) and lock.
Replace the bolts (arrows).
Parts: Screw

Tighten screws (arrows).

TIGHTENING TORQUES SPECIFICATION

Connector bracket for active stabilizer to side member
M6 Replace screw.
	Tightening torque	4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.