Adjusting the camshafts with the special tool

Keep the set of special tools 2 456 372 ready:

Number	Description
1	Basic carrier
2	Setting gauge for adjusting the intake camshaft
3	Setting gauge for adjusting the exhaust camshaft
4	Basic carrier screws on cylinder head
5	Screw gauge on basic carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Use the setting gauge 0.7° (1) from the special tool kit 2 456 372 to adjust the intake camshaft.
Use the setting gauge 0.5° (2) from the special tool kit 2 456 372 to adjust the exhaust camshaft.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the basic carrier (1) from the set of special tools 2 456 372 on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1) from special tool set 2 456 372 on the basic carrier (2).

TIGHTENING TORQUE SPECIFICATIONS

Basic carrier to cylinder head
M6	Tightening torque 8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Rotate the intake camshaft (E) and the exhaust camshaft (A) so that the marks (1) are legible from above.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the cam (1) on the exhaust camshaft on cylinder 1 is pointing slightly to the inside right at an angle.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the cam (1) on the intake camshaft on cylinder 1 is pointing leftwards at an angle.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the flattened areas (1) on the intake camshaft and the exhaust camshaft are pointing upwards at an angle.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the setting gauge 0.5° (2) from the set of special tools 2 456 372 between the exhaust camshaft and the basic carrier (1) from the set of special tools 2 456 372 .
Position the setting gauge 0.7° (3) from the set of special tools 2 456 372 between the intake camshaft and the basic carrier (1) from the set of special tools 2 456 372 .
Tighten down screws (4).

TIGHTENING TORQUE SPECIFICATIONS

Test gauge to basic carrier
M6	Tightening torque 8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.