Removing C-pillar trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to REMOVING ARMREST SIDE SECTION .
- Refer to REMOVING THE BOTTOM C-PILLAR TRIM PANEL .
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Lever out the cover panel (1) from the C-pillar trim panel (2) with a suitable tool.
- Loosen screw.
- Release the nuts (3) and (4).
- Feed the C-pillar trim panel (2) out and upwards and remove.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to REMOVING ARMREST SIDE SECTION .
- Refer to REMOVING THE BOTTOM C-PILLAR TRIM PANEL .
- Refer to REMOVING THE REAR DOOR SILL COVER STRIP (ON ELECTRICAL REAR SEAT) .
- Refer to REMOVING THE BOTTOM LEFT C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
WARNING:
Airbag unit
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Lever out the cover panel (1) from the C-pillar trim panel (2) with a suitable tool.
- Release screw below it.
- Loosen expanding rivet (3).
- Loosen screw (4).
- Feed the C-pillar trim panel (2) out and upwards and remove.