Install the side trim panel in the footwell at the left A-pillar
- Check the clip (4) for damage.
Replace the faulty clip (4).
- Position the side trim panel (3) and engage on clip (4).
- Make sure that the side trim panel (3) is correctly fitted against edge protection.
- Install the expanding rivet (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Side trim panel in footwell on A-pillar | ||
|---|---|---|
| screw | Tightening torque | 2.8 Nm |
- Install hood release lever (1).
- Pull the hood release lever (1) to the rear.
- Install the locking mechanism (2).
Follow-up work
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
- Refer to INSTALLING THE FRONT DOOR SILL COVER STRIP .