Installing the protective plate on the transmission
- Equip the screws (2) with a sealing washer (3) and a washer (4) as shown in the smaller image.
The sealing washer (3) must be between the protective plate and the washer (4).
- Check whether a washer and a sealing washer are present on the screw points of the body.
If necessary, replace the damaged sealing washers and fix using adhesive.
- Feed in the protective plate (1) and position it correctly.
- Tighten the screws (arrows) and the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Protective plate to the underbody | ||
|---|---|---|
| Flat-head screw M10x30 | tightening torque | 32 Nm |
| Hexagon screw M6 | tightening torque | 4 Nm |