12 36 CONTROL SYSTEM, HYBRID/ELECTRIC DRIVE (X5 xDrive 45e, 2021-)
12 36 TIGHTENING TORQUE OVERVIEW
| Battery ground lead to electrical machine electronics | |||
| M8x16 | Observe notes on earth bonding screw connections! | Tightening torque | 19 Nm |
| Coolant line to electrical machine electronics | |||
| M6x30 | Tightening torque | 8 Nm | |
| High-voltage cable to electrical machine electronics | |||
| M6x25 | Tighten screws in crosswise sequence | Joining torque | 3 Nm |
| Tightening torque | 8 Nm | ||
| High-voltage connector to electric drive unit | |||
| M8x46 | Tightening torque | 19 Nm | |
| Holder for electrical machine electronics (ELE) to electrical machine electronics (ELE) | |||
| M6x30 | Replace screws. | Joining torque | 8 Nm |
| Angle of rotation | 90° | ||
| Holder for electrical machine electronics to body | |||
| M8x20 | Replace screws. | Tightening torque | 28 Nm |
| Angle of rotation | 90° | ||
| Holder for electrical machine electronics to units compartment | |||
| M6x16 | Replace screws. | Tightening torque | 12 Nm |
| Angle of rotation | 90° | ||
| Holder for tension relief | |||
| M6 | tightening torque | 8 Nm | |
| Holder for tension relief to electrical machine electronics | |||
| M6 | Replace screws. | Joining torque | 4 Nm |
| Angle of rotation | 45° | ||
| Positive battery cable to electrical machine electronics | |||
| M8x16 | Tightening torque | 15 Nm | |
| Potential equalization line to electrical machine electronics | |||
| M8x16 | Observe notes on earth bonding screw connections! | Tightening torque | 19 Nm |