Removing the front flashing beacon
NOTE:
RISK OF DAMAGE
Mechanical effects .
Paint damage .
Mechanical effects .
Paint damage .
- Mask those working areas at risk with yellow plastic adhesive tape.
- Remove and install heavy or bulky components with the aid of another person/other persons.
Preliminary work
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING THE TOP LEFT COVER IN THE ENGINE COMPARTMENT , and REMOVING THE TOP RIGHT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING SEAL FOR FRONT BONNET .
- Refer to REMOVING TOP AUTOMATIC AIR FLAP CONTROL .
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Unlock plug connection (1) and disconnect.
- Remove the cable tie (2).
- Loosen screws (1).
- Disassemble the flashing beacon (2) from the holder and remove it.