Installing the model inscription
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
CAUTION:
Laser beam
.
Injury hazard!
Injury hazard!
- Do not look into the laser beam.
- Park the vehicle and the special tool 2 407 566 on a flat and even surface.
- Mount the laser on the tripod.
- Switch on laser (Position without automatic level).
- Activate laser horizontally and vertically.
- Position the tool behind the vehicle.
- Align the vertical laser beam on the edge of tailgate with the dimension (A) = 4.5 cm.
- Align the horizontal laser beam on the edge of tailgate with the dimension (B) = 3 cm.
- Remove the adhesive residue and clean the bonding surface with the cleaner R2.
CONSUMABLE SPECIFICATIONS
| Cleaning agent R2 | 500 ml | 83190417324 |
- Pull off the liner (protective film) from the adhesive strips of the model inscription.
- Align the model inscription on the laser beam and press onto the tailgate.
- Position the tool behind the vehicle.
- Align the vertical laser beam on the edge of tailgate with the dimension (A) = 4.0 cm.
- Align the horizontal laser beam on the edge of tailgate with the dimension (B) = 3.5 cm.
- Remove the adhesive residue and clean the bonding surface with the cleaner R2.
CONSUMABLE SPECIFICATIONS
| Cleaning agent R2 | 500 ml | 83190417324 |
- Pull off the liner (protective film) from the adhesive strips of the model inscription.
- Align the model inscription on the laser beam and press onto the tailgate.