Install rear window wiper motor

• Check the rubber grommet for damage and replace if necessary.
• Remount the rubber grommet of the rear wiper.

  The mark (1) on the rubber grommet of the rear wiper must match the mark (2) on the tailgate.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in the rear wiper motor (1) through the rubber grommet (2) and screw in by a few turns using the screws (3).
• Tighten the screws (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear wiper motor
  Torx bolt	tightening torque	7.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (1) on the rear window wiper motor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TAILGATE TRIM PANEL .
• Refer to INSTALLING TRUNK COMPARTMENT LIGHT ON TRUNK LID .
• Refer to INSTALL THE POWER TAILGATE SWITCH .
• Refer to INSTALLING THE TRIM FOR THE LEFT AND RIGHT SIDE REAR WINDOW FRAME .
• Refer to INSTALL THE TRIM FOR THE TOP REAR WINDOW FRAME .
• Refer to INSTALLING WIPER ARM OF THE REAR WIPER .