Removing the pressure line between the air conditioning compressor and the air conditioning condenser
CAUTION:
Refrigerant circuit under high pressure
.
Injury hazard!
Injury hazard!
- Note and follow safety instructions on containers.
- Avoid contact with refrigerant; wear safety goggles and hand protection.
- For additional information see: SAFETY INSTRUCTIONS FOR HANDLING TETRAFLUORETHANE REFRIGERANT R134A , or INSTRUCTIONS FOR HANDLING R1234YF REFRIGERANT and NOTES FOR REPAIR WORK ON AIR CONDITIONING .
Preliminary work
- Refer to SUCTION THE AIR CONDITIONING .
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE ENGINE CONTROL UNIT COVER .
- Refer to REMOVING THE BRACKET FOR THE DME CONTROL UNIT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Loosen screws (1).
- Remove the pressure line (2) from the air conditioning compressor (3) and set it aside.
- Loosen screw (1).
- Feed out and remove the pressure line (2) between the air conditioning compressor and the air conditioning condenser.