Installing right intake plenum (cylinder head removed)
- Replace the seal (4).
Parts: Gasket
- Only during replacement of the intake plenum:
Loosen screws (1).
Unlock pressure sensor (2) on the retaining tab (3).
Remove pressure sensor (2).
Position pressure sensor (2).
Retaining tab (3) must audibly lock in.
Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONSPressure sensor screw Tightening torque 3 Nm - Position the left intake plenum.
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Intake plenum M6 screw Tightening torque 10 Nm - Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Intake plenum | ||
| M8 screw | Tightening torque | 21.4 Nm |