Tighten the screw connection on the camber control arm

• Release nut (1).
• Pull out screw (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen joint bush/air suspension 

• Note that the knurled screw (1) on special tool 2 472 195 always points to the center of the vehicle.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and position special tool 2 472 195 on camber arm.
• Apply knurled screw (1) hand-tight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Align cam (2) on the special tool 2 472 195 with the joint bush.
• Tighten spindle (1) to its limit until hand-tight.

  Joint bush is detached and loosened from camber control arm.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release spindle (1).
• Unscrew the knurled screw (2) and remove the special tool 2 472 195 .

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the screw (2) and the nut (1).

  Parts:  Bolt, nut

• Insert screw (2).
• Tighten nut (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear spring strut/air suspension on camber control arm
  M14 Replace screw and nut. Tighten in NORMAL POSITION .	Joining torque  Angle of rotation	165 Nm 90°

• Release nut (1) one revolution. Provide counter support to screw (2) in the process.
• Tighten nut (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Anti-roll bar link to camber control arm
  M10 Replace screw and nut. Tighten in NORMAL POSITION .	Joining torque  Angle of rotation	56 Nm 90°

• Release nut (3) one revolution. Provide counter support to the eccentric screw in the process.
• Tighten nut (3).