Installing the holder for the DME control unit on the left
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Position the holder (2) for the DME control unit.
- Insert and install the holder (1).
The lock (arrow) must audibly engage.
- Insert and install the holder (3) for the DME control unit.
- Connect the wiring harness section (2) to the holder (3) in the arrow direction and lock.
The locks (1) must engage audibly.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Control unit holder | ||
|---|---|---|
| Hexagon screw | Tightening torque | 8 Nm |
- Connect connectors (2) and lock.
The connector (2) must engage audibly.
- Secure the clamp (1).
Follow-up work
- Refer to INSTALLING THE DME CONTROL UNIT OF CYLINDERS 5 TO 8 .
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .