Removing both actuators
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to BRINGING FRONT COMPARTMENT LID IN THE SERVICE POSITION .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING RIGHT SUSPENSION STRUT BRACE .
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING THE CENTER COWL UPPER PART .
- Refer to REMOVING ACOUSTIC COVER AT REAR .
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION
NOTE:
The figure shows the rear of the engine.
- Position special tool 2 360 895
correctly on the actuator (1) of the intake side.
- Turn the intake side actuator (1) with the special tool 2 360 895 by approx. 50° in the arrow direction and release it.
NOTE:
The figure shows the rear of the engine.
- Position special tool 2 360 895
correctly on the actuator (1) of the exhaust side.
- Turn the exhaust side actuator (1) with the special tool 2 360 895 by approx. 50° in the arrow direction and release.
NOTE:
The figure shows the rear of the engine.
- Unlock both plug connections (1) and disconnect.
- Feed out and remove both actuators.