Installing the servomotor for the eccentric shaft (cylinder head removed)
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Replace seal (1)
.
Parts: Gasket
- Press the seal (1)
up to the limit position on the housing.
- Grease the gearing (1)
of the servomotor (2)
for the eccentric shaft in marked area.CONSUMABLE SPECIFICATION
Lubricating grease Longtime PD-1 400 g, Cartridge 83192160340 - Clean sealing surface (1)
.
- Feed in and install the servomotor (1) for the eccentric shaft up to the stop.
- Turn the servomotor (1) for the eccentric shaft with a commercially available Allen wrench (2) with 4 mm in arrow direction until the servomotor (1) lies on the cylinder head for the cylinder head.
- Tighten down screws (3) .
TIGHTENING TORQUES SPECIFICATION
| Electrical servomotor to cylinder head | ||
|---|---|---|
| M6 | Tightening torque | 8 Nm |